...
Before inserting TITAN into the gearbox, connect TITAN to GCS via Blu-Link or USB-Link. You can download GCS here: https://www.gatee.eu/gcs
The GCS Information for Use is here: https://www.gatee.eu/manuals
Set up an accountCheck for latest firmware updates.
Now you’re ready to install TITAN in the gearbox.
Installation
Caution
Regardless of your previous experience, follow all safety precautions to prevent any damage to your TITAN.
Caution
TITAN installation requires deep technical knowledge of gearbox internals. To avoid damage, we recommend it to be installed by a skilled person. If, however, you wish to proceed with TITAN installation on your own, you must watch the installation video and read the full-length PDF manual: https://www.gatee.eu/manuals beforehand. Incorrect installation may result in amongst others sensor damage, which is not covered by warranty.
| Info |
|---|
Note |
| Info |
|---|
Note |
| Info |
|---|
Note |
Note
In case of any difficulties installing or using this product:
email us at support@gatee.eu;
contact us via Facebook: https://www.facebook.com/gatee;
call us on (+48) 12 210 05 23.
TITAN V2
Caution
A sector gear can damage the gear sensor during installation. Avoid this damage.
*grafika*
Caution
An insulation washer is required. Placing washers in the wrong order will cause a short circuit and permanent damage to TITAN, which is not covered by warranty.
*podobna grafika co w przypadku NGRS czy V2*
Caution
Incorrect placement of wiring under the motor gear may cause insulation damage and a short circuit, which is not covered by warranty.
...
Caution
ICS gearboxes require modification to avoid TITAN damage.
*grafika*
Caution
Do not pull the trigger when the gearbox is open. This may result in trigger sensor damage.
inna grafika
...
Note
In the case of some triggers (e.g. speed or CNC triggers), the first trigger sensor(s) may be covered even when the trigger is not pulled, which is due to its design.
...
Note
The fire selector sensor does not detect black surface. If the fire selector does not come with a metal connector or it does not work properly, you must use an appropriate sticker from the kit.
...
Note
Sticker position is crucial. Make sure to align it exactly to the left edge and the top red line.
The set contains 3 different sticker types. First, use the one with the thinner black line. If you are not able to calibrate the selector, try the other ones.
Caution
In TITAN V2 connectors must be bent according to the photo below. Bending connectors in the opposite direction may cause them to break. If this happens, spare terminals are included in the installation kit.
...
Instructions
| Info |
|---|
Powiązane artykuły
...