Versions Compared

Version Old Version 13 New Version 14
Changes made by

Sebastian Florek-Paszkowski

Sebastian Florek-Paszkowski

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Tip

Note
Sticker position is crucial. Make sure to align it exactly to the left edge and the top red line.

The set contains 3 different sticker types. First, use the one with the thinner black line. If you are not able to calibrate the selector, try the other ones.

...

Note

Caution
In TITAN V2 connectors must be bent according to the photo below. Bending connectors in the opposite direction may cause them to break. If this should happen, spare terminals are included in the installation kit.

...

Image Added

TITAN V3

...

Tip

Note
TITAN V3 fits CNC gearboxes with very low backlash. While fitting TITAN, pull the cables and at the same time push the board into the right place. Pay attention to the area marked yellow to fit the board correctly.

Note

Caution

Use a metal washer with a max. 8 mm [0.31 in] diameter to avoid TITAN damage.

Tip

Note
Use the trigger sticker to make it visible for the trigger sensor.

Tip

Note
TITAN can detect trigger position very precisely. In order to use it, you need to eliminate trigger backlash. The set contains 3 trigger anti-backlash stickers of various thicknesses. Try each one of them and choose the most appropriate one.

Tip

Note
The selector plate requires modification. Place the selector sticker according to the photos below. Its position is crucial.

Tip

Caution

In TITAN V3 the connectors must be straight according to the photo below. Bending and straightening the connectors back may cause them to break. If this happens, spare terminals are included in the installation kit.

...