Versions Compared

Version Old Version 17 New Version 18
Changes made by

Sebastian Florek-Paszkowski (Unlicensed)

Sebastian Florek-Paszkowski (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Warning

Warning
If you are using a recoil system and set excessive trigger sensitivity, it may cause incidental discharge (firing) even without pressing the trigger.

Warning

Warning
If you are using a recoil system and set excessive trigger sensitivity, it may cause accidental discharge (firing) even without pressing the trigger.

Warning

Warning
Pay attention to correctly solder positive and negative TITAN wires to the connector. Incorrectly connecting positive and negative battery terminals will cause immediate damage to the device, which is not covered by warranty, and can lead to fire.  

Note

Caution
An insulation washer is required. Placing washers in the wrong order will cause a short circuit and permanent damage to TITAN, which is not covered by warranty.

Note

Caution
Do not locate the screw in the cut-off lever hole to secure the TITAN board. Use a contact block mounting screw in the hole indicated by the arrow.

Note

Caution
Incorrect placement of wiring under the motor gear may cause insulation damage and a short circuit, which is not covered by warranty.

Note

Caution
In order to secure the wires properly, modify the gearbox as shown in the photos below.

Tip

Note
The selector plate requires modification. Place the selector sticker according to the photos below. Its position is crucial.

Note

Caution
In TITAN NGRS connectors should be bent according to the photo below. Bending connectors in the opposite direction may cause them to break. If this happens, spare terminals are included in the installation kit.

...