...
Click here 1️⃣ to go to Restore Default Settings 2️⃣ – restores default settings for the various functionalities. Trigger and selector calibration as well as statistics remain unchanged and 3️⃣ Restore Factory Settings – (hard reset) restores all default settings, resets your statistics, and clears adaptation data.
4️⃣ Cycle detection – allows to switch OFF or ON Detection – switches ON or OFF the optical gear sensor. Cycle detection Detection OFF can be compared to an emergency mode for problems with the “emergency mode” for troubles with gear sensor. Most of TITAN features will be disabled, but you can still shoot on ‘AUTO’in AUTO.
5️⃣ Thanks to the gear sensor, TITAN precisely detects in which position the cycle should finish. Therefore, even the shortest Trigger action produces at least one full cycle.
6️⃣
7️⃣ Battery protection – modern LiPo and LiFe batteries are very sensitive to over-discharge. The microprocessor monitors the battery voltage constantly. When the voltage drops down to a critical level, it will not allow firing.
Battery cell – when the battery voltage drops to the specified level (in relation to one cell), the motor will vibrate. You can set: OFF, 3.2V or 3.4V per cell for LiPo battery and 2.7V or 2.9V per cell for LiFe battery.
30-Round Limit – an AEG can continuously fire max. 30 BBs. To fire more BBs, you must release the Trigger before. This is protection against Trigger jam. Important: in case of emergency, you can also stop firing by switching the Selector position.
Active brake - it automatically adjusts the motor’s braking power according to your needs. This prolongs the lifespan of the motor and reduces the heat. Now you can also choose your own value depending on your needs.
8️⃣
9️⃣ Gear ratio - to make the PRE-COCKING work with the highest level of precision you should define the gears type in your AEG. Available types: STANDARD, HIGH TORQUE, HIGH SPEED, DSG, 19-TOOTH.
Typical gear ratio settings (excluding DSG and 19-tooth):
HIGH TORQUE: <15 RPS
STANDARD: 15-25 RPS
HIGH SPEED: >25 RPS
If overspin issue occurs, you should switch the gear type to the next level (e.g. STANDARD to HIGH TORQUE).
🔟 Active brake - it automatically adjusts the motor’s braking power according to your needs. This prolongs the lifespan of the motor and reduces the heat. Now you can also choose your own value depending on your needs.
| Tip |
|---|
Note |
| Tip |
|---|
Note |
Trigger
...
Pre-cocking – allows for initial spring compression, which speeds up the Trigger response significantly:
AUTO MODE – the spring is automatically compressed after each shot
Trigger MODE – slow Trigger action compresses the spring, and fast Trigger action fires the shot
Please note: using PRE-COCKING increases wear and tear on the gearbox.
...