Page Comparison

GREEN 1 s on start

Self-test was completed with succesfully

• Blu-Link is ok

• Wait for further LED indications

GLOWING GREEN

Blu-Link has been connected correctly

BLUE BLINKING for 120 s

Blu-Link is ready for Bluetooth connection®

Connect Blu-Link to GCS

GLOWING RED

Self-test failed, Bluetooth® connection is not possible

• Disconnect the power supply from Blu-Link, wait 10 seconds, and reconnect the power supply

• If you have a USB-Link, connect it to the INPUT connector, go to Diagnostics in GCS, check Blu-Link DTCs and follow the instructions there

• Contact us at support@gatee.eu

BLINKING IN RED/BLUE

• No Blu-Link firmware installed
  

• Self-test failed, Bluetooth® connection is possible

• Install Blu-Link firmware via GCS

• Connect Blu-Link to GCS, go to Diagnostics in GCS, check Blu-Link DTCs and follow the instructions there

BLUE GLOWING for 120 s

Blu-Link is connected correctly

Enjoy using Blu-Link

GLOWING ORANGE

Blu-Link firmware update in progress

• Wait until the firmware has been updated

• Keep the device with GCS on as close as possible to Blu-Link

Image Removed

Image Added

LED goes off 120 s after the last indication

• Battery saving mode

• Battery disconnected

• Enjoy using Blu-Link

• Connect battery

Image Removed

Image Added

LED goes off immediately after connecting the battery

• The battery is discharged or damaged

• Battery Deans-T connector is not compatible
  

• Damaged power cables

• Charge or replace the battery
  

• Use the Deans-T battery connector included with the installation kit

• Replace power cables

BLINKING RED

Overload, DTC displayed: 2 – ULL, 3 – OCP, 4 – SCP, 5 – OTP

Read what to do in the next section of the Manual or connect Blu-Link to GCS

BLINKING YELLOW

Zbyt niskie napięcie, wyświetlany kod DTC: 1 – UVP1, 2 – UVP2, 3 – UVP3

Przeczytaj co zrobić w części Kody Usterek lub podłącz Blu-Link do GCS i sprawdź zakładkę Diagnostics