Tip

Note
In case you have any difficulties while installing or using this product:

email us at support@gatee.eu
contact us via Facebook: https://www.facebook.com/gatee
call +48 12 210 05 23

Technical Specifications

11,1 VDC

Supply Nominal Voltage Range	4,75-17 VDC	Rated Voltage
Nominal Current	30 A
Nominal Current Consumption no load	280 uA
Maximum Current Consumption no load	45 mA (for 17 VDC)
Dimensions (Length x Width x Thickness)	54,5 mm x 19,9 mm x 9 mm
Finished Product Weight	9,65 g
Operating Temperature Range	min. -15° C, max. +50° C
Relative Humidity	≤ 80%

...

WHAT HAPPENED	POSSIBLE REASON	WHAT TO DO
ULL – User load limit exceeded	The load limit has been set too low in relation to AEG configuration Other possible reasons are the same as in the case of OCP or SCP	Modify the adjustable smart fuse settings Follow the OCP or SCP guidelines Contact us at support@gatee.eu
OCP – Blu-Link has detected excessive current activating overcurrent protection	Motor damaged Motor or gearbox jammed Motor connection short circuit	Replace the motor Unjam the motor or gearbox Check and fix motor wire insulation
SCP – Blu-Link has detected a current over 270 A activating short circuit protection	Damaged motor Jammed motor Motor damaged Motor or gearbox jammed Motor connection short circuit	Replace the motor Unjam the motor or gearbox Check and fix motor wire insulation
OTP – Blu-Link temperature is too high activating over temperature protection	Excessively high outside temperature in combination with a tuned replica Frequent short circuits and Blu-Link electrical overloads	Wait until Blu-Link temperature drops
UVP1 – Battery protection was activated.	Discharged batteryBattery discharged	Charge the battery
UVP2 – The voltage has dropped below the critical level for Blu-Link to work properly	The battery is Battery discharged. The battery is worn out and has excessively high internal resistance Inadequate battery type for current AEG configuration Too much electrical resistance between Blu-Link and the battery The motor is too powerful for the battery connected Motor connection short circuit Jammed motor Damaged motor	Charge the battery Replace the battery Use a battery of a greater capacity or voltage Do not use any adaptors Use standard or high-torque motors instead of high-speed ones Check and fix the motor wire insulation Unjam the motor Replace the motor
UVP3 – Protection against battery overdischarge activated immediately after the battery was connected	The number of cells differs from the number set in GCS Discharged battery Battery discharged	Set the same number of cells in GCS as in the battery Charge the battery