...
| Tip |
|---|
Note |
Trigger
...
...
1️⃣ Use Trigger Preferences to calibrate your trigger. You can only make changes once you've connected your replica with an ETU inside.
...
2️⃣ Pre-Cocking allows for initial spring compression, which speeds up Trigger response significantly:
Auto – the spring is automatically compressed after each shot. In Auto you can also set Boost, which determines the strength of spring compression. The highest setting results in the best Trigger response, but also greatly increases wear and tear on the gearbox.
If overspin occurs, set Gear Ratio to High Speed.
| Tip |
|---|
Note |
Manual – you can set the custom values to on SEMI, BURST, and AUTO.screen
...
| Note |
|---|
Caution |
3️⃣ ROF Control enables a reduction in a gun’s Rate of Fire. You can use stronger LiPo batteries, and still have a ROF just like in a real gun. ON – ROF control enables the reduction of a gun’s Rate of Fire. You can use stronger batteries and still have an ROF exactly as you like. Depending on Firmware edition, you can choose from among the following settings:
Off
Adaptive ROF control allows you to set the target Rate of Fire in rounds per second.
Manual PWM uses Pulse-Width Modulation to decrease ROF.
Manual Delay adds breaks between shots to decrease ROF.
Manual Delay + PWM combines Pulse-Width Modulation and breaks between shots.
...
ROF Control uses PWM (Pulse Width Modulation) to decrease ROF. Thanks to this, the gearbox works smoothly, which decreases wear and tear of AEG internal parts. The percentage value determines the PWM duty cycle and it does not reflect ROF decrease.
OFF – ROF Control adds breaks between shots to decrease ROF, which gives you a more realistic experience. This option set to 50% will significantly reduce ROF.
4️⃣ You don't need to fully release the Trigger to fire the next shot. This option is really useful when the Trigger sensitivity level is very high. Choose between two types of Equalizer:
...
1LVL, 2LVL and MANUAL are especially useful when trigger sensitivity level is very high, so you do not need to fully release the trigger while firing quickly:
...
5️⃣ Sniper Delay lets you to set delay between each SEMI shot to simulate the delay from reload or recoil. You can set it between 0.01 and 5 s. By choosing the Manual with Vibration option, you can enable a vibration which will inform you when the gun is ready to fire again.
...
Selector
...
Selector mode – allows you to choose how your replica will behave in each Selector position:
SAFE – the replica will not fire when the Trigger is pulled
SEMI – one pull of the Trigger will result in only one shot
BURST – one pull of the Trigger enables you to shoot a pre-determined number of BBs, which is very useful in MILSIM and when using low-caps
AUTO – pulling the Trigger causes an uninterrupted* series of shots until the Trigger is released
*the series can be limited by the Round Limit.
...