Content Comparison

Table of Contents

minLevel	1
maxLevel	7

...

Note
Caution A sector gear can damage the gear sensor during installation. Avoid this such damage.

...

Note
Caution An insulation washer is required. Place the washers according to the graphic below. Placing washers in the wrong order will cause a short circuit and permanent damage to TITAN, which is not covered by warranty.

...

Tip
Note The selector sensor does not detect black surface. If the selector does not come with a metal connector or it does not work properlyis not working correctly, you must use an appropriate sticker from the INSTALLATION KIT.

...

Tip
Note To run Programming via Trigger, your AEG must have a physical 3-stage selector.

Turning on

...

Switch the selector on your replica to SEMI or BURST.* If AUTO mode is selected in SEMI position, use the alternative method below.
Fire a shot or burst and do not release the trigger.
Hold the trigger for 7 seconds – until you hear a vibration.

...

TITAN V2 has the following optical sensors:
1 sector gear sensor
2 selector sensors
5 trigger sensors

...

Please read the installation guide below before proceeding.

...

TITAN V3 has the following optical sensors:

1 sector gear sensor
1 selector sensor
1 proximity trigger sensor

...

Please read the installation guide below before proceeding.

...

TITAN V2 NGRS has the following optical sensors:

2 gear sensors
1 selector sensor
1 trigger sensor
1 bolt catch sensor

...

Please read the Installation Guide below before proceeding.

...