HOW TO MAKE
QUANTUM TRIGGER
Tools
3D printer
Dremel with diamond wheel or precision hacksaw
Cyanoacrylate glue
Printer, paper, scissors
Regular trigger
...
5. Mark (using eg. a pencil) signs on the trigger according to the cutting line on the Quantum Trigger Overlay:
|
|
|
6. Draw a cutting line
...
9. Glue Quantum Trigger Overlay onto the prepared, degreased trigger:
  |   |
10. Wait until the glue dries out.
11. Gently cut off the part marked in blue with the sharp knife (according to the cutting line):
 |  |
1112. Print the Quantum Trigger sticker in A4 format, real scale (100%) from the PDF document attached to this manual and stick it to the marked area:
...
1213. Congratulations! The trigger is ready to use. Remove the white sticker from the gearbox and recalibrate trigger sensor.
...