...
| Code Block |
|---|
Improved:
- trigger sensor functionality
- selector mode configuration in Programming via Trigger changed from SAFE-BINARY-SEMI to SAFE-SEMI-BINARY
- Programming via Trigger card available in https://help.gatee.eu/
Added:
- brushless motor support
- brushless motor configuration without connecting to GCS
- trigger sensitivity regulation without connecting to GCS
- Pre-cocking Boost configuration without connecting to GCS
- full access to Telemetry data previously available only with EXPERT firmware
- service mode that allows you to check the operation of the gear sensor during installation without using GCS
- Magazine Capacity: 115 BBs
- Reload time: 0.5 s
- Low ammo warning: 10 BBs
- Sniper delay: 0.2 s/0.5 s
- Cycle detection: Manual |
...
| Code Block |
|---|
Improved: - trigger sensor functionality - selector mode configuration in Programming via Trigger changed from SAFE-BINARY-SEMI to SAFE-SEMI-BINARY - Programming via Trigger card available in https://help.gatee.eu/ Added: - brushless motor support - brushless motor configuration without connecting to GCS - trigger sensitivity regulation without connecting to GCS - Pre-cocking Boost configuration without connecting to GCS - full access to Telemetry data previously available only with EXPERT firmware - service mode that allows you to check the operation of the gear sensor during installation without using GCS - Low ammo warning: 20 BBs - ROF Control: Adaptive: 1/2/3/...100 RPS - Cycle detection: Manual |
...
| Code Block |
|---|
Improved:
- trigger sensor functionality
- selector mode configuration in Programming via Trigger changed from SAFE-BINARY-SEMI to SAFE-SEMI-BINARY
- Programming via Trigger card available in https://help.gatee.eu/
Added:
- brushless motor support
- brushless motor mode available without connecting to GCS
- trigger sensitivity adjustment without connecting to GCS
- Pre-cocking Boost configuration without connecting to GCS
- service mode that allows you to check the operation of the gear sensor during installation without using GCS |
v3.5-02 [2021-08-09]
| Code Block |
|---|
Added: - communication with STATUS Removed: - Programming via Trigger Improved: - sending selector state to STATUS |
...