...

• O-ring 16x1.5 x1

• O-ring 8x1 x2

• O-ring 6x1 x1

• O-ring 4x1 x1

Troubleshooting 

Low FPS

Check:

• No airtightness between the hop-up bucking and the nozzle

1. Check the air tightness between the hop-up bucking and the nozzle, check the hop-up chamber

2. Replace the nozzle/hop-up chamber HPA with another one

• Non-optimal engine settings in

...

• GCS

1. Restore the default settings of the HPA Engine

2. Increase Main Valve Time

...

There is no nozzle cycle – TP NM warning pops up in GCS

• If the replica is firing correctly but the TP NM error warning appears in the GCS application, it may be because shots were taken fired without connected pressure.

...

1. Disassemble the replica and remove the gearbox

2. Open the gearbox

3. Remove the damaged tappet plate spring and make sure that no part of it is left in the gearbox – a part of the spring left behind may cause malfunction of the tappet plate

4. Install a standard nozzle tappet plate spring from an AEG replica – we suggest using soft springs e.g. Retro Arms

5. Reassemble the gearbox and the replica

• Hop-up bucking collar curls up

1. If you have an EON hop-up chamber, use an offset clip

2. Use a different hop-up bucking

3. Use a shorter nozzle

Sudden scattering of BBs when previously everything was working correctly

...

1. Disassemble the replica and remove the gearbox

2. Open the gearbox

3. Remove the damaged tappet plate spring and make sure that no part of it is left in the gearbox – a part of the spring left behind may cause malfunction of the tappet plate

4. Install a standard nozzle tappet plate spring from an AEG replica – we suggest using soft springs e.g. Retro Arms

5. Reassemble the gearbox and the replica

• Hop-up bucking collar curls up

1. If you have an EON hop-up chamber, use an offset clip

2. Use a different hop-up bucking

3. Use a shorter nozzle

No BB feed

• The tappet plate spring is broken

...