...
| Note |
|---|
Caution
An insulation washer is required. Place the washer(s) according to the graphic below. Placing washers in the wrong order will cause a short circuit and permanent damage to TITAN, which is not covered by warranty. |
| Note |
|---|
Caution
If the PCB does not perfectly fit in your shell, make the necessary modifications to the gearbox shell, not to the PCB.
It is forbidden to make any modifications to the PCB shell such as drilling the screw hole, grinding the edges of the PCB, etc. Doing so may result in immediate damage to the circuit, which is not covered by the warranty. |
...
| Note |
|---|
Caution
Do not locate the screw in the cut-off lever hole to secure the TITAN board. Use a contact block mounting screw in the hole indicated by the arrow. |
...
TITAN V2 has the following optical sensors:
1 sector gear sensor
2 selector sensors
5 trigger sensors
...
Installation
Please read the installation guide below before proceeding.
...
TITAN V3 has the following optical sensors:
1 sector gear sensor
1 selector sensor
1 proximity trigger sensor
...
Installation
Please read the installation guide below before proceeding.
...
TITAN V2 NGRS has the following optical sensors:
2 gear sensors
1 selector sensor
1 trigger sensor
1 bolt catch sensor
...
Installation
Please read the Installation Guide below before proceeding.
...