| Table of Contents | ||||
|---|---|---|---|---|
|
...
Fire a shot, burst or pull the trigger while in SAFE mode (only if the safety lever has been removed) and do not release the trigger.
Switch the selector within 2 s. There is a single low frequency vibration.
Switch the selector in any order to change between the options indicated by vibrations:
1 low vibration – Pre-Cocking Off
2 low vibrations – Pre-Cocking Auto
3 low vibrations – Pre-Cocking Manual
Release the trigger to save the selected mode.
De-Cocking
Forcing the piston release after firing with Pre-Cocking enabled
Press the trigger in SEMI or BINARY mode and wait for the firing cycle to end – do not release the trigger.
After 1.5 s, a high, medium, high, medium, high, medium frequency audible message will be triggered.
Releasing the trigger after the sound message is equivalent to firing without Pre-Cocking. The piston remains in the rest position.
| Tip |
|---|
Note |
Profile Selection
Profiles are sets of particular settings of configurable TITAN functions. You can choose one of the three profiles at a time. Go to General>Profiles>Change Profile via Selector in GCS to be able to use this function. If you want to change the active profile:
...
TITAN V2 has the following optical sensors:
1 sector gear sensor
2 selector sensors
5 trigger sensors
...
Installation
Please read the installation guide below before proceeding.
...
TITAN V3 has the following optical sensors:
1 sector gear sensor
1 selector sensor
1 proximity trigger sensor
...
Installation
Please read the installation guide below before proceeding.
...
TITAN V2 NGRS has the following optical sensors:
2 gear sensors
1 selector sensor
1 trigger sensor
1 bolt catch sensor
...
Installation
Please read the Installation Guide below before proceeding.
...