Notice
Keep the Blu-Link box or save PIN printed on it – you will need it in case the device is damaged, lost or stolen.

Troubleshooting

Notice
Blu-Link troubleshooting during its connection is described on Troubleshooting Card included in the kit.

DTC Codes

Do troubleshooting:
(komunikaty w trakcie działania blu-linka)

To jest wersja do zredagowania, teksty są przykładowe!

LED (komunikat trwa max 2s) powtarzać cyklicznie przez 120sek z przerwami 3sek pomiedzy cyklami powtarzania komunikatow z przerwami 1 s pomiedzy bezpiecznikami	WHAT HAPPENED	WHAT TO DO
Image Added	UVP1 Protection against over-discharge of the battery. Battery protection was activated.	Charge the battery
Image Added	UVP2 The voltage dropped below ??? V which is critical for Blu-Link to work properly.	Charge the battery Replace the battery Use a battery with more capacity or higher voltage Do not use any adapters
Image Added	UVP3 (okrojone do 2sek) Protection against over-discharge of the battery. Battery protection was activated immediately after connecting the battery.	Set the same number of cells in GCS as in the battery Charge the battery
Image Added	OVL Too high voltage on battery.	Replace the battery
Image Added	OCP Blu-Link detected too high current. Over current protection was activated.	???
Image Added	SCP Blu-Link detected current over 220 A. Short circuit protection was activated.	???
Image Added	OTP Blu-Link temperature is too high. Over temperature protection was activated.	Wait until the temperature drops