Notice
In case you have any difficulties while installing or using this product:
a) email us at support@gatee.eu
b) contact us via Facebook: https://www.facebook.com/gatee
c) call (+48) 122-100-523

How to use Blu-Link

Plug and play

Attach Blu-Link to the AEG battery top side up
If LED is glowing green, go to the next step. If not, see Blu-Link Troubleshooting Card (included in the kit)
Connect the battery with attached Blu-Link to the AEG/ETU
Place the battery in the stock
Enjoy using Blu-Link

...

Notice
Keep the Blu-Link box or save PIN printed on it – you will need it in case the device is damaged, lost or stolen.

Troubleshooting

Notice
Blu-Link troubleshooting during its connection is described on Troubleshooting Card included in the kit.

DTC Codes

Do troubleshooting:
(komunikaty w trakcie działania blu-linka)

To jest wersja do zredagowania, teksty są przykładowe!

...

LED
(komunikat trwa max 2s) powtarzać cyklicznie przez 120sek

z przerwami 3sek pomiedzy cyklami powtarzania komunikatow
z przerwami 1 s pomiedzy bezpiecznikami

Diagnostic Trouble Codes (DTC) enable detecting basic malfunctions and problems with your AEG or Blu-Link. You are notified of these main errors with LED blinking for 2 minutes since the problem occurs. DTC can be later read and cleared in DTC menu in GCS app.

LED	WHAT HAPPENED	WHAT TO DO
	UVP1 Protection against over-discharge of the battery. Battery protection was activated.	Charge the battery
	UVP2 The voltage dropped below ??? V which is critical for Blu-Link to work properly.	Charge the battery Replace the battery Use a battery with more capacity or higher voltage Do not use any adapters
	UVP3 (okrojone do 2sek) Protection against over-discharge of the battery. Battery protection was activated immediately after connecting the battery.	Set the same number of cells in GCS as in the battery Charge the battery
	OVL Too high voltage on battery. Replace the battery load. The load limit was exceeded.	???
	OCP Blu-Link detected too high current. Over current protection was activated.	???
	SCP Blu-Link detected current over 220 A ???. Short circuit protection was activated.	???
	OTP Blu-Link temperature is too high. Over temperature protection was activated.	Wait until the temperature drops