LED | WHAT HAPPENED | WHAT TO DO |
|---|
 | UVP1
Protection against over-discharge of the battery. Battery protection was activated. | Charge the battery |
 | UVP2
The voltage dropped below ??? V which is critical for Blu-Link to work properly. | Charge the battery Replace the battery Use a battery with more capacity or higher voltage Do not use any adapters Use standard or high-torque motors instead of high-speed Check and fix the motor wires insulation Unjam the motor Replace the motor
|
 | UVP3
Protection against over-discharge of the battery. Battery protection was activated immediately after connecting the battery. | Set the same number of cells in GCS as in the battery Charge the battery
|
 | OVL
Too high load. The load limit was exceeded. | ??? |
 | OCP
Blu-Link detected too high current. Over current protection was activated.??? | Replace the motor Unjam the motor or gearbox Check and fix the motor wires insulation
|
 | SCP
Blu-Link detected current over 220 A ???. Short circuit protection was activated.??? | Replace the motor Unjam the motor or gearbox Check and fix the motor wires insulation
|
 | OTP
Blu-Link temperature is too high. Over temperature protection was activated. | Wait until the temperature drops |