Page Comparison

Congratulation on your new Blu-Link!

...

1. Download and install GATE Control Station:
   www.gatee.eu/gcs

2. Enable Bluetooth function on your device

3. Prepare Blu-Link DTC troubleshooting card included in the kit

4. Plug Blu-Link into AEG battery, LED side up. LED should glow green for 1 s.

5. Read the LED status and relate to DTC troubleshooting card

6. Log into the GCS app

7. Prepare PIN printed on the Blu-Link PIN card

8. Connect Blu-Link by following the instructions from the GCS

9. Plug Blu-Link into AEG/ETU

10. Enjoy using of the Blu-Link

...

1. The color of LED reflects on the problem type:

   1. Yellow indicates a warning

   2. Red indicates a critical problem

2. Number of blinks determines what exactly the problem is (for reference, read DTC explanations presented later on in this guide)

DTC explanations

• grafika - flaga w kolorze i z liczba plus strzałki wyjaśniające

• dodać za liczbą mignięć znak “x” np. 2x

• przemyśleć bardziej obrazowe oznaczanie liczby mignięć, np. warfet, 4 błyśnięcia:

  

Notice
If you use an ETU connected to Blu-Link, check also the ETU DTC. Blu-Link is designed to withstand higher power load and lower voltage than ETU, so in most cases, the ETU protection turns on earlier and the Blu-Link does not detect the problem.

...