| Table of Contents |
|---|
v4.1-05 [2024-07-10]
| Code Block | ||
|---|---|---|
| ||
Improved:
- sensor diagnostics mode removed |
v4.1-04 [2024-04-25]
| Code Block | ||
|---|---|---|
| ||
Improved: - UVP1 protection operation - 2-stage trigger - SEMI mode operation with BLDC motors - ROF Adaptive operation - removed showing and clearing DTCs in the Programming via Trigger menu. The ADVANCED function now includes options for: 1. restoring default settings 2. restoring factory settings 3. setting trigger sensitivity with the ability to check the currently set sensitivity Added: - DECOCKING - full adjustment of Active Break (0 |
...
-100%) even when Pre-Cocking is enabled |
v4.0-03 [2023-07-24]
| Code Block | ||
|---|---|---|
| ||
Improved:
- ROF Control functioning of the following types: Manual Delay and Adaptive
- Magazine Mode functioning |
v4.0-02 [2023-07-07]
| Code Block | ||
|---|---|---|
| ||
Improved:
- cycle control
- Pre-Cocking mode
- BINARY mode when Sniper Delay mode is enabled
Added:
- setting any brake force value in Brushless mode
- setting any brake force value in BASIC firmware
- a new diagnostic mode for the gear sensor, trigger, and selector;
the diagnostic mode is available when the system is installed in the gearbox |
v4.0-01 [2022-08-24]
BASIC, ADVANCED and EXPERT
Improved:
SAFE / SEMI / BINARY instead of SAFE / BINARY / AUTO selector mode
new Programming via Trigger card available at https://help.gatee.eu/
Added:
brushless motor support
brushless motor configuration without connecting to GCS
trigger sensitivity adjustment without connecting to GCS
pre-cocking boost adjustment without connecting to GCS
automatical pre-cocking: LOW / MID / HIGH
service mode that allows you to check the operation of the gear sensor during installation without using GCS
BASIC
Added:
new Magazine Capacity option: 115 BBs
new Reload time option: 0.5 s
new Low ammo warning option: 10 BBs
new Sniper delay option: 0.2 s/0.5 s
new Cycle detection mode: Manual
ADVANCED
Improved:
...
...
new Programming via Trigger card available at https://help.gatee.eu/
Added:
...
brushless motor support
...
brushless motor configuration without connecting to GCS
...
trigger sensitivity adjustment without connecting to GCS
...
pre-cocking boost adjustment without connecting to GCS
...
:
...
new Low ammo warning option: 20 BBs
new Adaptive ROF Control mode: 1/2/3/...100 RPS
new Cycle detection mode: Manual
EXPERT
Improved:
SAFE / SEMI / BINARY instead of SAFE / BINARY / AUTO selector mode
new Programming via Trigger card available at https://help.gatee.eu/
Added:
brushless motor support
brushless motor configuration without connecting to GCS
trigger sensitivity adjustment without connecting to GCS
pre-cocking boost adjustment without connecting to GCS
automatical pre-cocking: LOW / MID / HIGH
service mode that allows you to check the operation of the gear sensor during installation without using GCS
v3.5-02
| Code Block |
|---|
Improved: - sending selector state to STATUS |
...