Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Warning

Warning
This device is not a toy and may not be operated by people (including children) with limited physical or mental abilities, as well as by people with no earlier experience in operation of electronic equipment. They may use the device only under the supervision of people responsible for their safety.

...

Warning

Warning
Do not store or carry flammable liquids, gases or explosive materials in the same compartment as the device, its parts or accessories.  

Warning  Excessive Trigger sensitivity may cause unintentional discharge (firing). 
Warning
Warning

Warning  
When an airsoft gun is not in use, its battery must be disconnected and the hop-up chamber must be empty.

Warning

Warning  
While handling an AEG with a connected battery, anyone within the range of the replica must wear personal protective equipment.

Warning

Warning
When not in SAFE mode, avoid using the device around strong electromagnetic fields, such as PMR transmitters exceeding European standards or when electrostatic discharges, e.g. lightning, occur in the atmosphere, which may cause malfunction of the device and unintentional discharge (firing).

Warning

Warning
Always use a well insulated and fully functional cable and charger.

...

Note

Caution
Do not disassemble or take apart STATUS. The casing has been sealed in two places:
beneath the two display mounting screws, where the display adjoins the body and
around the screw facing the RIS railhousing has been secured with warranty seals. Any broken seal voids warranty.

...

Tip

Note
In case you have any difficulties while installing or using this product:

Initial Use

Tip

Note
The battery in your STATUS is not charged. Before the first use, you need to connect STATUS to a power supply for 3 hours.

  1. Once the battery has been charged, attach STATUS to the RIS rail on either side of the replica depending on your eye preference.

  2. Connect STATUS to GCS via Blu-Link. You can download GCS here: https://www.gatee.eu/gcs .

    Image Added

     

     

    Image Added

     

Tip

Note
Bluetooth 4.0 or higher is required.

Tip

Note
STATUS can be attached on either side of your replica. If attached on the right-hand side, change display orientation in GCS, the buttons will be reassigned too.

Tip

Note
STATUS is on whenever connected to a power supply.

 

Continue:
Information for Use (In4U) [STS]

Go back to:
/wiki/spaces/RD/pages/1651834881
Safety & Regulatory Information [STS]

Technical Specifications

Supply Voltage Range

4,753-17 5 VDC

Rated Voltage

11,1 3.7 VDC

Nominal Current Consumption

280 uA

Maximum Current Consumption

45 mA (for 17 VDC)

Dimensions (Length x Width x Thickness)

54,5 47 mm x 19,9 60 mm x 9 54 mm

Finished Product Weight

9,65 180 g

Operating Temperature Range

min. -15° 20° C, max. +50° 60° C

Relative Humidity

≤ 80%

Bluetooth® Trademark Attribution

...

GATE Enterprise sp. z o.o. sp. k. hereby declare under our sole responsibility that GATE Blu-Link STATUS is in conformity with the essential requirements of the following directives: 2012/19/UE, 2014/53/UE, 2011/65/UE.

...

Go next to:
Installation Guide (InstaG) [STS]

Go back to:
QuickStart Guide (QSG) [STS] /wiki/spaces/RD/pages/1651834881
Information for Use (In4U) [STS]

Filter by label (Content by label)
showLabelsfalse
max5
spacescom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@a32
sortmodified
showSpacefalse
reversetrue
typepage
cqllabel = "kb-how-to-article" and type = "page" and space = "RD"
labelskb-how-to-article

...