| Table of Contents | ||||
|---|---|---|---|---|
|
v4.1-05 [2024-07-10]
| Code Block | ||
|---|---|---|
| ||
Improved:
- sensor diagnostics mode removed
Added:
- Support for M4 replicas, with selector fire modes spaced every 45 degrees |
v4.1-04 [2024-04-25]
| Code Block | ||
|---|---|---|
| ||
Improved: - UVP1 protection operation - 2-stage trigger - SEMI mode operation with BLDC motors - ROF Adaptive operation - removed showing and clearing DTCs in the Programming via Trigger menu. The ADVANCED function now includes options for: 1. restoring default settings 2. restoring factory settings 3. setting trigger sensitivity with the ability to check the currently set sensitivity Added: - DECOCKING - full adjustment of Active Break (0-100%) even when Pre-Cocking is enabled |
v4.1-01 [2024-02-22]
| Code Block | ||
|---|---|---|
| ||
Improved:
- notification of the gear cam condition communicated to GCS |
v4.0-03 [2023-07-21]
| Code Block | ||
|---|---|---|
| ||
Improved:
- functioning of selector calibration for GCS and for calibration mode (available after restoring factory settings)
- ROF Control functioning of the following types: Manual Delay and Adaptive
- Magazine Mode functioning |
v4.0-02 [2023-07-07]
| Code Block | ||
|---|---|---|
| ||
Improved: - cycle control - Pre-Cocking mode - BINARY mode when Sniper Delay mode is enabled Added: - setting any brake force value in Brushless mode - setting any brake force value in BASIC firmware - MANUAL Pre-Cocking for DSG - a new diagnostic mode for the gear sensor, trigger, and selector; the diagnostic mode is available when the system is installed in the gearbox |
...