| Table of Contents | ||||
|---|---|---|---|---|
|
v4.1-05 [2024-07-10]
| Code Block | ||
|---|---|---|
| ||
Improved:
- sensor diagnostics mode removed
Added:
- Support for M4 replicas, with selector fire modes spaced every 45 degrees |
v4.1-04 [2024-04-25]
| Code Block | ||
|---|---|---|
| ||
Improved: - UVP1 protection operation - 2-stage trigger - SEMI mode operation with BLDC motors - ROF Adaptive operation - removed showing and clearing DTCs in the Programming via Trigger menu. The ADVANCED function now includes options for: 1. restoring default settings 2. restoring factory settings 3. setting trigger sensitivity with the ability to check the currently set sensitivity Added: - DECOCKING - full adjustment of Active Break (0-100%) even when Pre-Cocking is enabled |
v4.1-01 [2024-02-22]
| Code Block | ||
|---|---|---|
| ||
Improved:
- notification of the gear cam condition communicated to GCS |
v4.0-03 [2023-07-21]
| Code Block | ||
|---|---|---|
| ||
Improved: - functioning of selector calibration for GCS and for calibration mode (available after restoring factory settings) - ROF Control functioning of the following types: Manual Delay and Adaptive - Magazine Mode functioning |
v4.0-02 [2023-07-07]
| Code Block | ||
|---|---|---|
| ||
Improved:
- cycle control
- Pre-Cocking mode
- BINARY mode when Sniper Delay mode is enabled
Added:
- setting any brake force value in Brushless mode
- setting any brake force value in BASIC firmware
- a new diagnostic mode for the gear sensor, trigger, and selector; the diagnostic mode is available when the system is installed in the gearbox |
...