Improved:
- trigger sensor functionality
- selectordiagnostics mode configuration in Programming via Trigger changed from SAFE-BINARY-SEMI to SAFE-SEMI-BINARY
- Programming via Trigger card available in https://help.gatee.eu/

Added:
- brushless motor support
- brushless motor configuration without connecting to GCS
- trigger sensitivity regulation without connecting to GCS
- Pre-cocking Boost configuration without connecting to GCS
- full access to Telemetry data previously available only with EXPERT firmware
- Magazine Capacity: 115 BBs
- Reload time: 0.5 s
- Low ammo warning: 10 BBs
- Sniper delay: 0.2 s/0.5 s
- Cycle detection: Manual

Improved:
- UVP1 protection operation
- 2-stage trigger
- SEMI mode operation with BLDC motors
- ROF Adaptive operation
- removed showing and clearing DTCs in the Programming via Trigger menu. The ADVANCED function now includes options for: 
  1. restoring default settings
  2. restoring factory settings
  3. setting trigger sensitivity with the ability to check the currently set sensitivity
Added:
- DECOCKING
- full adjustment of Active Break (0-100%) even when Pre-Cocking is enabled

Improved:
- ROF Control functioning of the following types: Manual Delay and Adaptive
- Magazine Mode functioning

Improved:
- cycle control
- Pre-Cocking mode
- BINARY mode when Sniper Delay mode is enabled

Added:
- brushlesssetting motorany supportbrake -force brushlessvalue motorin configuration without connecting to GCS
Brushless mode
- triggersetting sensitivityany regulationbrake withoutforce connectingvalue toin GCSBASIC -firmware
Pre-cocking Boosta configurationnew withoutdiagnostic connectingmode tofor GCSthe -gear fullsensor, accesstrigger, toand Telemetryselector; data
previouslythe availablediagnostic onlymode withis EXPERTavailable firmwarewhen -the Lowsystem ammois warning:installed 20in BBsthe - ROF Control: Adaptive: 1/2/3/...100 RPS
- Cycle detection: Manual