Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Version History

« Previous Version 19 Next »

v4.1-05 [2024-07-10]

Improved:
- sensor diagnostics mode removed
fixed a problem with restoring factory settings when the trigger is connected to the Multifunctional Port
Added:
- Support for M4 replicas, with selector fire modes spaced every 45 degrees

v4.1-04 [2024-04-25]

Improved:
- UVP1 protection operation
- 2-stage trigger
- SEMI mode operation with BLDC motors
- ROF Adaptive operation
- removed showing and clearing DTCs in the Programming via Trigger menu. The ADVANCED function now includes options for: 
  1. restoring default settings
  2. restoring factory settings
  3. setting trigger sensitivity with the ability to check the currently set sensitivity
Added:
- DECOCKING
- full adjustment of Active Break (0-100%) even when Pre-Cocking is enabled

v4.0-03 [2023-07-24]

Improved:
- ROF Control functioning of the following types: Manual Delay and Adaptive
- Magazine Mode functioning

v4.0-02 [2023-07-07]

Improved:
- cycle control
- Pre-Cocking mode
- BINARY mode when Sniper Delay mode is enabled

Added:
- setting any brake force value in Brushless mode
- setting any brake force value in BASIC firmware
- a new diagnostic mode for the gear sensor, trigger, and selector; 
the diagnostic mode is available when the system is installed in the gearbox

v4.0-01 [2022-08-24]

BASIC, ADVANCED and EXPERT

Improved:

  • SAFE / SEMI / BINARY instead of SAFE / BINARY / AUTO selector mode

  • new Programming via Trigger card available at https://help.gatee.eu/

Added:

  • brushless motor support

  • brushless motor configuration without connecting to GCS

  • trigger sensitivity adjustment without connecting to GCS

  • pre-cocking boost adjustment without connecting to GCS

  • automatical pre-cocking: LOW / MID / HIGH

  • service mode that allows you to check the operation of the gear sensor during installation without using GCS

BASIC

Added:

  • new Magazine Capacity option: 115 BBs

  • new Reload time option: 0.5 s

  • new Low ammo warning option: 10 BBs

  • new Sniper delay option: 0.2 s/0.5 s

  • new Cycle detection mode: Manual

ADVANCED

Added:

  • new Low ammo warning option: 20 BBs

  • new Adaptive ROF Control mode: 1/2/3/...100 RPS

  • new Cycle detection mode: Manual

v3.5-02

Improved:
- sending selector state to STATUS

v3.5-01

Added:
- communication with STATUS
Removed:
- Programming via Trigger

v3.4

Added:
- new PCB DATA revision support
  • No labels