Improved:
- trigger sensor functionality
- selector mode configuration in Programming via Trigger changed from SAFE-BINARY-SEMI to SAFE-SEMI-BINARY
- Programming via Trigger card available in https://help.gatee.eu/

Added:
- brushless motor support
- brushless motor configuration without connecting to GCS
- trigger sensitivity regulation without connecting to GCS
- Pre-cocking Boost configuration without connecting to GCS
- full access to Telemetry data previously available only with EXPERT firmware
- Magazine Capacity: 115 BBs
- Reload time: 0.5 s
- Low ammo warning: 10 BBs
- Sniper delay: 0.2 s/0.5 s
- Cycle detection: Manual

Improved:
- trigger sensor functionality
- selector mode configuration in Programming via Trigger changed from SAFE-BINARY-SEMI to SAFE-SEMI-BINARY
- Programming via Trigger card available in https://help.gatee.eu/

Added:
- brushless motor support
- brushless motor configuration without connecting to GCS
- trigger sensitivity regulation without connecting to GCS
- Pre-cocking Boost configuration without connecting to GCS
- full access to Telemetry data previously available only with EXPERT firmware
- Low ammo warning: 20 BBs
- ROF Control: Adaptive: 1/2/3/...100 RPS
- Cycle detection: Manual

Improved:
- trigger sensor functionality
- selector mode configuration in Programming via Trigger changed from SAFE-BINARY-SEMI to SAFE-SEMI-BINARY
- Programming via Trigger card available in https://help.gatee.eu/

Added:
- brushless motor support
- brushless motor mode available without connecting to GCS
- trigger sensitivity adjustment without connecting to GCS
- Pre-cocking Boost configuration without connecting to GCS

Improved:
- sending selector state to STATUS

Added:
- communication with STATUS
Removed:
- Programming via Trigger

Added:
- new PCB DATA revision support