v4.0-01 [2022-08-24]
BASIC, ADVANCED and EXPERT
Improved:
SAFE / SEMI / BINARY instead of SAFE / BINARY / AUTO selector mode
trigger sensor functionality: new noise-resistant trigger detection algorithm
new Programming via Trigger card available at https://help.gatee.eu/
Added:
brushless motor support
brushless motor configuration without connecting to GCS
trigger sensitivity adjustment without connecting to GCS
pre-cocking boost adjustment without connecting to GCS
automatical pre-cocking: LOW / MID / HIGH
service mode that allows you to check the operation of the gear sensor during installation without using GCS
BASIC
Added:
new Magazine Capacity option: 115 BBs
new Reload time option: 0.5 s
new Low ammo warning option: 10 BBs
new Sniper delay option: 0.2 s/0.5 s
new Cycle detection mode: Manual
ADVANCED
Added:
new Low ammo warning option: 20 BBs
new Adaptive ROF Control mode: 1/2/3/...100 RPS
new Cycle detection mode: Manual
v3.5-02 [2021-08-09]
Added: - communication with STATUS Removed: - Programming via Trigger Improved: - sending selector state to STATUS
v3.2-02 [2020-09-08]
Improved: - 2-stage trigger operation for Quantum Trigger - Fire selector operation at high ambient temperatures Fixed: - Elimination of a shot while switching from SAFE to SEMI when Quantum Trigger is pressed
v3.2 [2020-07-21]
Improved: - DTC error tracking if the trigger and/or selector - gear sensor support for GCS - other improvements
v3.1 [2020-07-01]
Fixed: - First shot failure after switching fire selector from SAFE Added: - Green LED blinks after connecting the battery if self test was passed successfully
v3.0-80 [2022-04-25]
Improved: - Operation of the trigger - Detecting of 2-cell battery - Removing of blockade after trigger sensor was overexposed - First shot failure after switching fire selector from SAFE - 2-stage trigger operation for Quantum Trigger - Fire selector operation at high ambient temperatures - DTC error tracking if the trigger and/or selector - Gear sensor support for GCS Other improvements Fixed: - Elimination of a shot while switching from SAFE to SEMI when Quantum Trigger is pressed Added: - Support for BLDC motors - Support for GATE Quantum Trigger™ - Green LED blinks after connecting the battery if self test was passed successfully
v3.0 [2019-11-20]
Improved: - Calibration of device without using GCS - Various improvements enhancing operation of the device
0 Comments