v4.1-01 [2024-02-22]
Improved: - notification of the gear cam condition communicated to GCS
v4.0-03 [2023-07-21]
Improved: - functioning of selector calibration for GCS and for calibration mode (available after restoring factory settings) - ROF Control functioning of the following types: Manual Delay and Adaptive - Magazine Mode functioning
v4.0-02 [2023-07-07]
Improved: - cycle control - Pre-Cocking mode - BINARY mode when Sniper Delay mode is enabled Added: - setting any brake force value in Brushless mode - setting any brake force value in BASIC firmware - a new diagnostic mode for the gear sensor, trigger, and selector; the diagnostic mode is available when the system is installed in the gearbox
v4.0-01 [2022-08-24]
BASIC, ADVANCED and EXPERT
Improved: - SAFE / SEMI / BINARY instead of SAFE / BINARY / AUTO selector mode - trigger sensor functionality: new noise-resistant trigger detection algorithm - new Programming via Trigger card available at https://gatee.eu/aster-se-qs Added: - brushless motor support - brushless motor configuration without connecting to GCS - trigger sensitivity adjustment without connecting to GCS - pre-cocking boost adjustment without connecting to GCS - automatic pre-cocking: LOW / MID / HIGH - service mode that allows you to check the operation of the gear sensor during installation without using GCS
BASIC
Added: - new Magazine Capacity option: 115 BBs - new Reload time option: 0.5 s - new Low ammo warning option: 10 BBs - new Sniper delay option: 0.2 s/0.5 s - new Cycle detection mode: Manual
ADVANCED
Added: - new Low ammo warning option: 20 BBs - new Adaptive ROF Control mode: 1/2/3/...100 RPS - new Cycle detection mode: Manual
v3.5-02 [2021-08-09]
Added: - communication with STATUS Removed: - Programming via Trigger Improved: - sending selector state to STATUS
v3.2-02 [2020-09-08]
Improved: - 2-stage trigger operation for Quantum Trigger - Fire selector operation at high ambient temperatures Fixed: - Elimination of a shot while switching from SAFE to SEMI when Quantum Trigger is pressed
v3.2 [2020-07-21]
Improved: - DTC error tracking if the trigger and/or selector - gear sensor support for GCS - other improvements
v3.1 [2020-07-01]
Fixed: - First shot failure after switching fire selector from SAFE Added: - Green LED blinks after connecting the battery if self test was passed successfully
v3.0-80 [2022-04-25]
Improved: - Operation of the trigger - Detecting of 2-cell battery - Removing of blockade after trigger sensor was overexposed - First shot failure after switching fire selector from SAFE - 2-stage trigger operation for Quantum Trigger - Fire selector operation at high ambient temperatures - DTC error tracking if the trigger and/or selector - Gear sensor support for GCS Other improvements Fixed: - Elimination of a shot while switching from SAFE to SEMI when Quantum Trigger is pressed Added: - Support for BLDC motors - Support for GATE Quantum Trigger™ - Green LED blinks after connecting the battery if self test was passed successfully
v3.0 [2019-11-20]
Improved: - Calibration of device without using GCS - Various improvements enhancing operation of the device
Add Comment