Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Version History

« Previous Version 4 Next »

Initial Use

  1. Before inserting TITAN into the gearbox, connect TITAN to GCS via Blu-Link or USB-Link. You can download GCS here: https://www.gatee.eu/gcs

    The GCS Information for Use is here: https://www.gatee.eu/manuals

  2. Check for latest firmware updates.

Now you’re ready to install TITAN in the gearbox.

Installation

Caution
Regardless of your previous experience, follow all safety precautions to prevent any damage to your TITAN.

Caution
TITAN installation requires deep technical knowledge of gearbox internals. To avoid damage, we recommend it to be installed by a skilled person. If, however, you wish to proceed with TITAN installation on your own, you must watch the installation video and read the full-length PDF manual: https://www.gatee.eu/manuals beforehand. Incorrect installation may result in amongst others sensor damage, which is not covered by warranty.

Note  
TITAN V2 and TITAN V3 do not support Infinite torque-up gears.

Note
Apply a thin layer of grease. Excessive grease may cover sensors or gaps between teeth, which will result in cycle detection issues. Use grease of appropriate viscosity and density to avoid splashing.

Note  
In the GCS App configure the gear type (if your gears are not stock) and perform first-time sensor calibration for TITAN V3 and TITAN V2 NGRS.

Note  
In case of any difficulties installing or using this product:

TITAN V2

Caution
A sector gear can damage the gear sensor during installation. Avoid this damage.

*grafika*

Caution
An insulation washer is required. Placing washers in the wrong order will cause a short circuit and permanent damage to TITAN, which is not covered by warranty.

*podobna grafika co w przypadku NGRS czy V2*

Caution
Incorrect placement of wiring under the motor gear may cause insulation damage and a short circuit, which is not covered by warranty.


Caution
ICS gearboxes require modification to avoid TITAN damage.

*grafika*

Caution
Do not pull the trigger when the gearbox is open. This may result in trigger sensor damage.

inna grafika

Note
In the case of some triggers (e.g. speed or CNC triggers), the first trigger sensor(s) may be covered even when the trigger is not pulled, which is due to its design.

Note
The fire selector sensor does not detect black surface. If the fire selector does not come with a metal connector or it does not work properly, you must use an appropriate sticker from the kit.

Note
Sticker position is crucial. Make sure to align it exactly to the left edge and the top red line.

The set contains 3 different sticker types. First, use the one with the thinner black line. If you are not able to calibrate the selector, try the other ones.

Caution
In TITAN V2 connectors must be bent according to the photo below. Bending connectors in the opposite direction may cause them to break. If this happens, spare terminals are included in the installation kit.

Instructions

 

Powiązane artykuły

Filter by label

There are no items with the selected labels at this time.

  • No labels