Versions Compared

Version Old Version 1 New Version Current
Changes made by

Jakub Janowicz

Aleksandra Hajdon (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Note

Caution
The adjustment of the TACTICKER is very sensitive; therefore, we recommend making no more than a quarter turn of the adjustment screw at a time to find the optimal setting. Over-tightening the screw (more than 2 turns) may cause the mechanism to lock. In such a case, the adjustment screw should be loosened until the mechanism becomes responsive again.

Note

Caution

Please remember to secure the TACTICKER adjustment screw with thread-locking adhesive after completing the adjustment.

  1. To adjust the trigger break force, use the screw located at the top of the body—tightening it increases the break force, while loosening it decreases it.
    For better trigger feel, it's recommended to perform this adjustment with the gearbox shell closed, manipulating the screw through the cylinder window. During this process, it's necessary to remove the HPA cylinder/engine assembly and use a long and narrow hex key (size 2.0mm 5/64").

...

  1. Depending on the type of trigger you have, you may achieve different trigger characteristics. When installed in a gearbox with a non-adjustable trigger or an adjustable trigger set in a neutral position, the TACTICKER will simulate a two-stage trigger.

    First stage - the initial resistance, which depends on the stiffness of the trigger spring.
    Second stage - the break point after which the shot is fired, and whose resistance is adjusted by the screw in the TACTICKER.

  2. For adjustable triggers, it is possible to set up a single-stage trigger and remove the trigger spring to achieve a lighter pull.
    To do this, adjust the trigger pretravel so that the trigger touches the TACTICKER firing pin in its initial position.

  3. After setting the desired trigger characteristics and resistance, you can reassemble the entire gearbox and install it in the replica. We recommend securing Remember to secure the TACTICKER adjustment screw with thread-locking adhesive before doing so.

...

  1. After installing the TACTICKER and gearbox, recalibrate the trigger in the GCS. During calibration, perform a full trigger pull (for a two-stage trigger, complete both the first and second stages of the trigger pull).

  2. After completing the calibration, pull the trigger until you feel the resistance of the TACTICKER needle.

    Image Removedtacticker-instrukcja-13-eng.jpgImage Added


    3. While keeping the trigger pulled in this position, set the shot moment and reset just before the trigger status indicator.

...

  1. Perform a test shot and check if it occurs after breaking the resistance of the TACTICKER. If the shot happens before breaking the resistance, adjust the reset and shot moment slightly further from the trigger status indicator.

    Image Removed165_stopni.jpgImage Added


    5. The TACTICKER is ready for use.

...