Page Comparison

...

1. After installing the TACTICKER and gearbox, recalibrate the trigger in the GCS. During calibration, perform a full trigger pull (for a two-stage trigger, complete both the first and second stages of the trigger pull).
   

2. After completing the calibration, pull the trigger until you feel the resistance of the TACTICKER needle.
   

   Image RemovedImage Added

   
   3. While keeping the trigger pulled in this position, set the shot moment and reset just before the trigger status indicator.

...

4. Perform a test shot and check if it occurs after breaking the resistance of the TACTICKER. If the shot happens before breaking the resistance, adjust the reset and shot moment slightly further from the trigger status indicator.
   

   Image RemovedImage Added

   
   5. The TACTICKER is ready for use.
   
   

...