v4.0-02 [2023-07-07]

Improved:
- cycle control
- Pre-Cocking mode
- BINARY mode when Sniper Delay mode is enabled

Added:
- setting any brake force value in Brushless mode
- setting any brake force value in BASIC firmware
- MANUAL Pre-Cocking for DSG
- a new diagnostic mode for the gear sensor, trigger, and selector; 
the diagnostic mode is available when the system is installed in the gearbox

v4.0-01 [2022-08-24]

BASIC, ADVANCED and EXPERT

Improved:

• SAFE / SEMI / BINARY instead of SAFE / BINARY / AUTO selector mode

• new Programming via Trigger card available at https://help.gatee.eu/

Added:

• brushless motor support

• brushless motor configuration without connecting to GCS

• trigger sensitivity adjustment without connecting to GCS

• pre-cocking boost adjustment without connecting to GCS

• automatical pre-cocking: LOW / MID / HIGH

• service mode that allows you to check the operation of the gear sensor during installation without using GCS

BASIC

Added:

• new Magazine Capacity option: 115 BBs

• new Reload time option: 0.5 s

• new Low ammo warning option: 10 BBs

• new Sniper delay option: 0.2 s/0.5 s

• new Cycle detection mode: Manual

ADVANCED

Added:

• new Low ammo warning option: 20 BBs

• new Adaptive ROF Control mode: 1/2/3/...100 RPS

• new Cycle detection mode: Manual

v3.5-02

Improved:
- sending selector state to STATUS

v3.5-01

Added:
- communication with STATUS
Removed:
- Programming via Trigger

v3.4

Added:
- new PCB DATA revision support